43 lines
2.1 KiB
Markdown
43 lines
2.1 KiB
Markdown
Rotary Dial
|
|
===========
|
|
|
|
Arduino library to read numbers from a rotary dial (or otherwise using pulse dialing; see [Wikipedia: Rotary dial](http://en.wikipedia.org/wiki/Rotary_dial)).
|
|
|
|
|
|
|
|
This implementation is for the North American system, where [1, 9] pulses correspond to the numbers [1, 9], and 0 is represented by 10 pulses. This library was written for use with the dial [demonstrated here](http://commons.wikimedia.org/wiki/File:Rotary_Dial,_Dialing_Back_with_LEDs.ogv) and pictured above.
|
|
|
|
Connection & Circuit
|
|
--------------------
|
|
|
|
On the back of the dial are two connections relevant for this implementation. One (the 'ready' switch) is normally open (NO), and is closed whenever the rotor is not at rest (specifically, as soon as the user draws back the rotor, and until it finishes returning). The other (the 'pulse' switch) is normally closed (NC), and is opened briefly for each pulse (roughly 10 - 20 Hz).
|
|
|
|
The expected circuit is:
|
|
|
|
Rotary Dial Arduino
|
|
/---------------------- readyPin
|
|
/- ready switch (NO) -- pull-up resistor -- VCC
|
|
/-- pulse switch (NC) -- pull-up resistor -/
|
|
\ \---------------------- pulsePin
|
|
\------------------------------------------ GND
|
|
|
|
The expected sequence is:
|
|
|
|
readyPin pulsePin state
|
|
HIGH n/a default (waiting)
|
|
LOW LOW ready to dial / for first pulse
|
|
LOW HIGH pulse received (number = 1)
|
|
LOW LOW ready for next pulse
|
|
LOW HIGH pulse received (number = 2)
|
|
LOW ... (repeat)
|
|
HIGH n/a rotation complete, count recorded
|
|
|
|
There is 15ms allowed for debounce, which is the implementation's only
|
|
constraint on pulse speed.
|
|
|
|
See Also
|
|
--------
|
|
|
|
See also: [USB output from the Arduino](http://www.arduino.cc/playground/Main/InterfacingWithHardware#USB), including [presenting the Arduino as a keyboard by installing new firmware](http://hunt.net.nz/users/darran/?tag=keyboard).
|
|
|