Go to file
starcalc f2a56d66a3 Aktualisiert 2018-04-26 23:10:18 +02:00
examples/dialtoserial Aktualisiert 2018-04-26 23:10:18 +02:00
README.markdown Initial commit 2018-04-26 18:10:33 +02:00
RotaryDialer.cpp Initial commit 2018-04-26 18:10:33 +02:00
RotaryDialer.h Initial commit 2018-04-26 18:10:33 +02:00

README.markdown

Rotary Dial

Arduino library to read numbers from a rotary dial (or otherwise using pulse dialing; see Wikipedia: Rotary dial).

front of a rotary telephone dial

This implementation is for the North American system, where [1, 9] pulses correspond to the numbers [1, 9], and 0 is represented by 10 pulses. This library was written for use with the dial demonstrated here and pictured above.

Connection & Circuit

On the back of the dial are two connections relevant for this implementation. One (the 'ready' switch) is normally open (NO), and is closed whenever the rotor is not at rest (specifically, as soon as the user draws back the rotor, and until it finishes returning). The other (the 'pulse' switch) is normally closed (NC), and is opened briefly for each pulse (roughly 10 - 20 Hz).

The expected circuit is:

     Rotary Dial                              Arduino
                      /---------------------- readyPin
  /- ready switch (NO) -- pull-up resistor -- VCC
 /-- pulse switch (NC) -- pull-up resistor -/
 \                    \---------------------- pulsePin
  \------------------------------------------ GND

The expected sequence is:

readyPin  pulsePin  state
HIGH      n/a       default (waiting)
LOW       LOW       ready to dial / for first pulse
LOW       HIGH      pulse received (number = 1)
LOW       LOW       ready for next pulse
LOW       HIGH      pulse received (number = 2)
LOW       ...       (repeat)
HIGH      n/a       rotation complete, count recorded

There is 15ms allowed for debounce, which is the implementation's only constraint on pulse speed.

See Also

See also: USB output from the Arduino, including presenting the Arduino as a keyboard by installing new firmware.